Home / Products / Accessories / Electrical / Heaters

5637376378 EKS NV PH
Electric heaters are designed to heat clean air in ventilation systems.
Casing is made from aluzinc coated steel which is high temperature proof. Heating elements tube is made from stainless steel AISI 304. In heaters are installed 2 protection thermostats, screw terminals for easy connection. Casing can be with PG connection, flanges or intended to install directly to AHU.
Heaters can be installed vertically or horizontally.
Maximum output air temperature 50°C.


down
Line below arrow

5637211677 EKA NV PH
Electric heaters are designed to heat clean air in ventilation systems. Casing is made from aluzinc coated steel which is high temperature proof. Heating elements tube is made from stainless steel AISI 304. There are 2 protection thermostats, screw terminals installed in heaters for easy connection. Casing is with rubber seals for duct connection. Heaters can be installed vertically or horizontally.
down
Line below arrow

5637211270 EKA NI
Heaters EKA NI with integrated temperature control, contains temperature regulator which works by algorithm impulse/pause, that enables fine temperature control. Regulator controls load by triacs without moving parts, which causes no-noise commutation. External temperature setpoint must be connected separately. The button of manual restoration located on the case of a heater.
down
Line below arrow

5637211326 EKA NIS
Heaters EKA ...NIS with integrated temperature control, contains temperature regulator which works by algorithm impulse/pause, that enables fine temperature control. Regulator controls load by triacs without moving parts, which causes no-noise commutation. The button of manual restoration located on the case of a heater. The external control signal (0-10V) is needed.
down
Line below arrow

5637211025 EKA NV
Heaters EKA NV with external temperature control. Electric heaters are designed to heat clean air in ventilation systems. Casing is made from aluzinc coated steel which is high temperature proof. Heating elements tube is made from stainless steel AISI 304. Heaters are equipped with 2 protection thermostats, screw terminals for easy connection. Casing is with rubber seals for duct connection. Heaters can be installed vertically or horizontally. Maximum output air temperature 50°C. External temperature setpoint must be connected separately. The button of manual restoration located on the case of a heater.
down
Line below arrow

5637210996 EKS
Electric heaters are designed to heat clean air in ventilation systems.
Casing is made from aluzinc coated steel which is high temperature proof. Heating elements tube is made from stainless steel AISI 304. In heaters are installed 2 protection thermostats, screw terminals for easy connection. Casing can be with PG connection, flanges or intended to install directly to AHU.
Heaters can be installed vertically or horizontally.
Maximum output air temperature 50°C.


down
Line below arrow

5637210682 EKA
Electric heaters are designed to heat clean air in ventilation systems. Casing is made from aluzinc coated steel which is high temperature proof. Heating elements tube is made from stainless steel AISI 304. In heaters are installed 2 protection thermostats, screw terminals for easy connection. Casing is with rubber seals for duct connection. Heaters can be installed vertically or horizontally. Maximum output air temperature 50°C.
down
Line below arrow

5637317080 ELVEKA
Electrical heaters for VEKA EC
down
Line below arrow

5637237578 VEGA EH
• 3 optional electrical heater models for each air supply unit VEGA.
• Supplied separately as an option.
• Easy integration/change at site.
• Integrated control board for automatic regulation.
• Controlled automatically according to temperature sensor.
down
Line below arrow

SALDA UAB
Ragainės g.100, Šiauliai LT-78109 LITHUANIA
Tel. +370 41 540 415 Fax. +370 41 540 417
office@salda.lt www.salda.lt